If done correctly, your object should power over and over again, and one side of the clock will light up at a time. If you are too slow, the entire circuit will lose power. If you are too fast, the entire circuit will stay powered. Quickly - within a second - break the torch and replace your redstone dust. Now, pick up your dust and hold it in your hand. Then, break the dust and replace it with a torch. Break the redstone in the middle on the far side from where you placed your object to power. Use one dust and your item that you would like to power and attach it to one end of the clock. Link the six repeaters together using ten dust, five on each end with a one block gap like the picture demonstrates. They must all face the same (opposite) direction and have zero delay. You can place these blocks by facing the opposite direction while placing them), with one block's gap between them. Place the next three repeaters next to the first three FACING THE OPPOSITE DIRECTION (the two torches at the top must be in the opposite direction. Make sure they all have zero delay (the two torches on the top of the block should be touching). First, lay out three repeaters all facing one direction. For this clock, you will need a 3x8 area for the redstone, something to power (in my case, a piston - but it is up to you), a redstone torch, eleven redstone dust, and six repeaters. (A clock circuit is a redstone circuit which produces a clock signal: a pattern of pulses which repeats itself.) This is a compact, simple, cheap and flexible clock for Minecraft using redstone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |